|
The DM 3000 is ideal for drilling holes in glass , polycarbonate and
plastic lenses. Opposing tapered drill bits bore holes simultaneously
from both sides of the lens, allowing for precise drilling while
safeguarding against chipping and breaking. After the hole is drilled
the lens reamer can be used to enlarge the hole to the desired size.
The lens support arm maintains the correct drilling angle.
Grooving
Useful built –in grooving device. You can adjust the depth of groove freely when grooving.
Sawdust receiving bucker, receives the sawdust of lens when cleaning the saw groove.
- Both drill bits function simultaneously from the upper and lower sides.
- Drill holes are rimmed with high accuracy, from 0.8 mm adjustable each.2.8mm.
- The lens is drilled by pushing the handle.
- Lens positioning dial and lens check pad for
convenient lens drilling. The dial sets the lens position. The distance
from an edge of the lens to the point to be drilled can be adjusted in
the range of 2.0mm to 8.0mm in steps of 0.5mm.
- Suction lens holder secures the lens at a fixed inclination.
- Hand rest stabilizes the hand for proper drilling.
- Oil Bath contains the cutting oil to be used for drilling glass (mineral) lenses.
- Adjustement of drill bits clearance it’s easy with allen key included
- Various replacement possibilities (reamer, drill bits, etc)
- Possibility of one-sided drilling with twist drill bit (optional)
Accessories
- Lens holder arm
- Cutting oil
- Allen key (3, 2.5 and 2mm)
- Suction Cup
- Drill bit holder
Specifications
Acceptable lens materials: Glass (mineral), Plastic
(CR-39), Polycarbonate, etc.
Possible diameter of drilling: Ø 0.8mm to Ø 2.8mm
Dimensions: 250 (W) x 220 (D) x
345 (H)mm
Weight: 4.8 Kg
Power requirements: 100 to 120V / 60Hz AC 25 or
200 to 240V / 50 Hz AC, 50
|
